Page 1 of 1

TinkerCAD Tutorial: Angled Wedges

Posted: Sat Apr 22, 2017 8:04 pm
by winternimbus
Greetings! I'm Sylandro, user of TinkerCAD.

Now, TinkerCAD is very easy to get a hold of, but if you're wondering "well how do i make angled wedges?" I'm your guy for the job.

Without further adieu, lets begin.


<big>RECTANGULAR ANGLED WEDGES</big>

Image

As seen on this CAD made by yours truly (the bot belongs to shaba though), you see that there are rectangular angled wedges near the corners of the robot. How do you make these?

They're the easiest type of angled wedges to make in TinkerCAD, and lets start&#33;


Image

First of all, grab a pyramid shape from the basic shapes list.

Image

Then, proceed to get two "hole" boxes, these shapes appear on the shape list like this:

Image

These shapes will come in handy, once you figure out how these nifty little tools work, sky's the limit&#33;

Proceed to click, and drag a box to select the pyramid shape, and the two "hole boxes".

Image

Once you clicked and selected the pyramid and the "hole" boxes, click the group button, which is the one shown in the image above.

Image

Congratulations&#33; You successfully have a angled, rectangular wedge. Feel free to use this shape, squash it, squeeze it to your own will.

--

Now, we're not done here just yet, i'm also going to cover triangular, angled wedges, lets begin.

<big>TRIANGULAR ANGLED WEDGES</big>


Image

As seen on my Rebel Yell, the front wedges sport triangular wedges, now these are a bit tricker to pull off, but once you get the hang of them, they're quite easy.

Image

Grab a triangle from the shapes menu/list and make it three-sided, like i did here.

Image

Proceed to rotate the triangle 45 degrees counter-clockwise.

Image

Grab two "hole" boxes, and align them, just like you did with the rectangular angled wedge, although you might need to tinker it until it fully aligns with the triangle.

Proceed to group the shapes.

Image

And we're done here&#33;

--


If you think i did a good job with this tutorial, please say so, and please give me advice for future tutorials. Also, if you thought this was helpful--please do say&#33;

TinkerCAD Tutorial: Angled Wedges

Posted: Sat Apr 22, 2017 8:28 pm
by Madman
If you wanna make a right-angled triangular wedge, you can rotate a pyramid 45 degrees and cut three of the corners off.
If you wanna make a plow out of a single piece, you can use the TinkerCAD Octagon that you'll find under 'Community Shape Generators'. Then just group with holes to cut away whatever you don't need.